All Products

This combustion blower motor is used on the D1LC model heaters p/n 25.1830.01. It will not fir the D1LC Compact models (D1LCC)

This printed circuit board is used on the B5L/B5LC/D5L and D5LC - 12 volt heaters

This is a 90mm hood for use on all B/D5L and B/D5LC heater

This temp sensor is mounted on the heat exchanger closeset to the glow plug. This temp sensor has a blue wire harness. It fits all B5L/D5L/B5LC and D5LC heaters, but DOES NOT fit the Airtronic series heaters

This plastic end cap is used on all heaters using the 25mm combustion air tube

This outlet hood is used when space is restricted. The hood incorporates a 90 degree discharge for use with 90mm ducting. It is used on B5L/D5L/B5LC and the D5LC. It DOES NOT fit the Airtronic series heaters.