All Products

This felt ring is used between the combustion blower and the heater exchanger on a D3L heater. Two (2) of these rings are required

This flame sensor fits all D9W and Hydronic 10 model heaters. Works in both 12 and 24 Volts heaters. This sensor DOES NOT work in the new M2 series.

This flame sensor will fit the B/D1LCC and B/D3LCC (compact) heaters. It will not fit the older ""LC"" family if heaters (external control unit)

Fuel Metering Pump (FMP) Harness Connector for HS3 Hydronic heaters and 2nd generation Airtronic D2L & D4L heaters

Black Plastic Fuel Line 2mm ID, used on all Gen. 1 Air and Coolant heaters, on suction side of the Fuel Metering Pump (fuel tank to FMP) sold by the meter.

This fuel metering pump is used on all D3L - 12 volt heaters